How much do you know about maintenance knowledge of Plastic gloss meter factory? Let's take a look at it briefly!
1. Avoid strong light during use.
2. The instrument is equipped with two standard boards. Keep it clean. It is not advisable to touch the surface with your fingers. If the surface is stained, the error of the instrument will increase and the reading will be inaccurate. If you touch it accidentally, you can wipe it with lens paper or absolute alcohol.
3. Due to the high stability of this instrument, the instrument does not need to be calibrated frequently. It is recommended to re-calibrate after 2 hours of continuous use.

4. This instrument is designed with a high battery usage rate. When the battery is used below 0.8V (battery power is exhausted), the reading of the instrument begins to decline, and the red light-emitting diode in the upper right corner of the instrument displays on, prompting the operator to replace the battery, and turn on the left side of the instrument. With the side battery compartment cover, the instrument can be reused. If the battery is exhausted, it should be replaced in time. Otherwise, if stored for a long time, the old battery may flow out of waste liquid and cause damage to the instrument.
5. During the calibration process, if it is found that the calibration value of the black glass standard cannot be reached after turning the calibration knob to the end, it may be that the optical lens of the instrument is seriously polluted. Wipe the lens with a little absolute alcohol with lens paper to solve the problem. problem.
In summary, it is a brief introduction to the relevant knowledge of Plastic gloss meter factory.